PCBWay Community:Your Home for PCB,Electrical Engineering & Electronics Community

Select Category

Choose Country

Mechanical Flower

by Malik from CHINA, PEOPLES REPUBLIC with 0.00
0 .00

DESIGN

0 .00

USABILITY

0 .00

CREATIVITY

0 .00

CONTENT
PCB Project of the Week Aug 21 - Aug 27,2023

Visit Case
1 Appreciate Project
Jury votes

Latest comments:

Engineer just recommended"3Ch Analog PWM LED Driver - Wemos D1 Mini / ESP (WLED)" to the fans
Engineer just recommended"ESP32 Starlight Ceiling Board for ESPHOME and WLED" to the fans
Sophie just recommended"Mechanical Flower" to the fans
Yusuf just recommended"OLEDTransistorTester" to the fans
Trond Even Evensen just recommended"OBD II GPS Tracker" to the fans
Engineer just commented on"Thor ControlPCB"
özdemir just recommended"OBD II GPS Tracker" to the fans
Engineer just recommended"WeMos D1 mini - WLED Controller (5-12V)" to the fans

PCBWay Videos

Learn more about our services and activities

View All

00:00:00

What are Thermal Relief Pads? | PCB Knowledge

PCB Knowledge
00:00:00

What is Embedded Passive Technology? | PCB Knowledge

PCB Knowledge
00:00:00

How are CNC parts produced?

PCBWay Introduction
00:00:00

What are PCB Test Coupons? | PCB Knowledge

PCB Knowledge

Top Questions

Share knowledge. Earn trust.

Krneta

JAPAN

XY Plotter Drawing Robot Board setup

Can you please share your contact where I can connect with you, I am planning to buy the "XY Plotter Drawing Robot Board". but I don't have any experience of how to work around arduino a...

1170 Views

1 Comments
PCBWay Support

CHINA, PEOPLES REPUBLIC

Clear soldermask and black core fr4 circuit board pcb manufacturer

Hello,does anyone know a chinese PCB fab that can do a PCB like this black FR-4 substrateIm looking for a fab house that can prototype a small batch (200pcs )of a fairly big 150x210mm P...

3085 Views

4 Comments
mehmetalidag

TURKEY

Best way to make a break-off section of PCB

I want to make a PCB as one design, but with a part as a 'break-off' section - see the picture with the large slot near the top of the board. The board measures about 130 x 100mm overall.Is th...

1909 Views

5 Comments
Aitesam

PAKISTAN

In KiCad, How should I designate the flex areas of a rigid-flex board?

I have a rigid-flex design which consists of two rigid sections connected by one flex section. How do I convey to the fabricator which areas I want rigid and which areas I want flex?

1939 Views

1 Comments

SHOW ALL QUESTIONS

Blog

PCB Basic Information

By PCBWay

What are counterbore and countersink? | PCB Knowledge

Counterbore holes are cylindrical with flat bottoms, while countersink holes are conical recesses designed to accommodate a screw or bolt. Both types serve to insert screws or fasteners, yet they offe...

1875 Views

2023-06-12
PCB Basic Information

By PCBWay

Multilayer PCB Stack-up Basics | PCB Knowledge

Single-layer PCBs and double-layer PCBs are two basic types of boards that have only one or two layers of conductive materials over the substrate. When more routing space or signal integrity is requir...

1818 Views

2023-05-26

SHOW ALL BLOGS

The PCBWay that recognize the talent and effort of the best ELECTRONIC designers in the World.

© COPYRIGHT 2019

About us
Contact us
Follow us on